What about just modifying a Tupperware sandwich container?
Secure the lid to a bulkhead and cut wire holes in the body of the Tupperware. Cheap and readily available. If done right, it keeps fingers, tools and falling water out and also allows ready access to the terminals for service and inspection.
The Tupperware seal is quite robust for an enclosure that is not fastened shut.
/Jason
Ok more info: the 50mv 200amp shunt reads ~23 mv at full throttle with the multi-meter. So I guess the cycle analyst has it wrong. I will try to figure out configuration options--it may be due to the splice I put in the line, so the resistance from that splice makes the analyst see a further drop in voltage. Not sure.
Anyway I was also wondering if someone might be able to recommend a good shunt enclosure? Something to keep the elements out. Also apparently the ABYC requires a cover around the shunt--or at least that's what I heard. So if any of you guys know about a plastic (or other) enclosure that would be great.Thanks for your help!Bradley
__._,_.___
| Reply via web post | • | Reply to sender | • | Reply to group | • | Start a New Topic | • | Messages in this topic (8) |
.
__,_._,___
No comments:
Post a Comment