Nice one, thanks for the link.
That should do perfectly.
--- In electricboats@yahoogroups.com, "RandyB" <bartlettrandy@...> wrote:
>
> I did this project.
>
> You need a center-tap pot. I used a 10,000 ohms 2 watt, wire-wound linear potentiometers, Part number 5905-258-6808 manufactured by Clarostat.
>
> They aren't that common, but there's one listed on ebay as "New* 10K ohm Clarostat Potentiometer Center Tap".
>
> It goes from 0 to 5k in each direction.
>
> I started out with three cams made from large fender washers, epoxied onto the pot shaft. I'll try to post a pix.
>
>
> --- In electricboats@yahoogroups.com, "mattelderca" <mattelderca@> wrote:
> >
> > I am looking for a pot and not having much luck so I thought I'd ask here. My controller uses a 5K pot, Max speed is at 5K ohms, I think this is the reverse of normal setups. I would like to have a center "off" pot to make a forward reverse throttle lever. I can use cams and micro switches for the for/rev solenoids.
> > But I cannot come up with a simple easy setup for the pot.
> > Any suggestions?
> >
>
No comments:
Post a Comment