Hi
i have a question to volks? From manul 1003 copied:
English
"7.4.3 Charging the batteries from the on-board batteries
It is possible to charge the battery from any DC voltage source
within a range of 9.5V ... 50V. The required minimum current is 4A.
Forchargingplease use a wire cross-section of at least 0.5 mmxmm.
The dimensions of the required barrel connector are 5.5/2.5 mm.
For example, it is a good idea to use the 12-V battery charger lead
made by Torqeedo. Pay attention to the polarity - see diagram."
From this coming: DC voltage, that means it can be use an battery without inverter and loader. It is all right?
Gina
On Sunday, May 31, 2015 4:22 AM, "thall90024@yahoo.com [electricboats]" <electricboats@yahoogroups.com> wrote:
I have a Torqeedo 1003 travel electric motor that I use on a Precision sailboat and a flat back canoe , a spare lithium ion battery cost $699, I have a couple of long trips planned with the canoe and am suffering from " range anxiety" . Torqeedo recently approved charging the battery while underway with a "house battery",
I have a AGM optima bluetop battery with a Samlex 150 watt pure sine wave inverter to run the Torqeedo fast 80 watt charger, I ordered a Heavy duty, in-line fuseholder for ATC/ATO type fuses. 10 gauge wire for up to 30 amp rating. My question is am I in danger of being electrocuted by running 110 power in a canoe with maybe a little water on the floor?
__._,_.___
Posted by: Adam Horvath <su64aanm@yahoo.com>
| Reply via web post | • | Reply to sender | • | Reply to group | • | Start a New Topic | • | Messages in this topic (3) |
.
__,_._,___
No comments:
Post a Comment