Duh :-)
eric SV Meander
--- In electricboats@yahoogroups.com, Jason Taylor <jt.yahoo@...> wrote:
>
> It looks to be a 13x13-LH, as written on one of the blades.
>
> /Jason
>
> On Jun 21, 2013, at 7:09, "cire" <cirejay@...> wrote:
>
> > What size is the new prop? It looks quite large.
> >
> > eric SV Meander
> >
> > --- In electricboats@yahoogroups.com, "jonathanheirendt" <jonathanheirendt@> wrote:
> > >
> > >
> > > Hi all,
> > > Here is a few photos of how the electric conversion has been going so far.
> > > http://groups.yahoo.com/group/electricboats/photos/album/247467376/pic/list
> > >
> > > You were right Mike, Getting the old motor out was a bit of a chore so hopefully the rest of the install will go smoothly. I will post more pics in a couple weeks when I get back to the boat. The old shaft coupling is fighting me pretty bad so my next step is to try some heat.
> > > liquid wrench, pully puller, and a BFH are not doing the trick. Also the prop I had bought was marked with the wrong size. Was listed as 3/4 but I measured it at 1". I have since orderd a Propeller bushing for it. Any Comments on these beauties? Do they work?
> > >
> > > http://www.getaprop.com/content-categories/cat-394_444/propeller_bushing_bronze.html
> > >
> > > Thanks for feedback, comments, etc.
> > >
> > > Jonathan
> > >
> >
> >
>
| Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (8) |
No comments:
Post a Comment