I had to spit mine @ the keyway with a hacksaw and it slid rite off
--- In electricboats@yahoogroups.com, "cire" <cirejay@...> wrote:
>
> What size is the new prop? It looks quite large.
>
> eric SV Meander
>
> --- In electricboats@yahoogroups.com, "jonathanheirendt" <jonathanheirendt@> wrote:
> >
> >
> > Hi all,
> > Here is a few photos of how the electric conversion has been going so far.
> > http://groups.yahoo.com/group/electricboats/photos/album/247467376/pic/list
> >
> > You were right Mike, Getting the old motor out was a bit of a chore so hopefully the rest of the install will go smoothly. I will post more pics in a couple weeks when I get back to the boat. The old shaft coupling is fighting me pretty bad so my next step is to try some heat.
> > liquid wrench, pully puller, and a BFH are not doing the trick. Also the prop I had bought was marked with the wrong size. Was listed as 3/4 but I measured it at 1". I have since orderd a Propeller bushing for it. Any Comments on these beauties? Do they work?
> >
> > http://www.getaprop.com/content-categories/cat-394_444/propeller_bushing_bronze.html
> >
> > Thanks for feedback, comments, etc.
> >
> > Jonathan
> >
>
| Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (10) |
No comments:
Post a Comment