Saturday, December 1, 2012

Re: [Electric Boats] Min kota

 

I had one fail. It was the crimp connector that connects to the brushes. One loosened up on the wire and lost contact. It was not really obvious right off.
I made up new wire, 8 gauage, and heavier crimps soldered as well. I found a decent place for parts if you need any.
http://www.northlandmarine.com/MinnKotaQuickRef.htm

 
mattelderca
From: Carel Ruysink <c.ruysink@hetnet.nl>
To: electricboats@yahoogroups.com
Sent: Saturday, December 1, 2012 11:04:41 AM
Subject: Re: [Electric Boats] Min kota

 
Brushes?
 
Carel.
----- Original Message -----
Sent: Saturday, December 01, 2012 2:51 PM
Subject: [Electric Boats] Min kota

 
Our minkota stopped working at the end of thos season. I pulled it apart and found the wires that go to the motor. Put power and ground dirrctly and no action. Pulled the motor out of the case and could not see or smell anything burnt. No sign that water evet got in. I figure it is time to replace it but just wanted to check if there was something I may have missed as these are usually pretty reliable. Any advice? Richard


Sent from Yahoo! Mail on Android


__._,_.___
Reply via web post Reply to sender Reply to group Start a New Topic Messages in this topic (3)
Recent Activity:
.

__,_._,___
Posted by at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)