Funny you should mention heat from the controller. I did some temperature measurements after several hours of operating on the cruise back from New York. Controller was about 118 degrees F at the top where the exhaust air comes out and the motor case was only 135 degrees F after four hours of operation. But, maybe ducting the heat from the motor might be a better solution than trying to use the Honda's output. No CO2 worries.<g>
Mike
http://biankablog.
--- On Tue, 9/22/09, aweekdaysailor <aweekdaysailor@
From: aweekdaysailor <aweekdaysailor@
Subject: Re: [Electric Boats] Using Honda 2000i heat
To: electricboats@
Date: Tuesday, September 22, 2009, 6:20 PM
Just mount your controller under the helm :)
[Non-text portions of this message have been removed]
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch format to Traditional
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
No comments:
Post a Comment