I read an article that said not to do that particular thing because it would cause excess electrolysis on that particular through hull.
Sent from my T-Mobile 4G LTE Device
From: electricboats@groups.io <electricboats@groups.io> on behalf of Ryan Sweet <ryan@ryansweet.org>
Sent: Thursday, December 3, 2020 4:01:33 PM
To: electricboats@groups.io <electricboats@groups.io>
Subject: Re: [electricboats] Grounding.
Sent: Thursday, December 3, 2020 4:01:33 PM
To: electricboats@groups.io <electricboats@groups.io>
Subject: Re: [electricboats] Grounding.
My understanding of this area is rudimentary, but I believe the goal is to eventually connect the ground to the bonding system that probably connects most of your brass or bronze through-hulls to your sacrificial anodes. I attached mine to a nut at the base of one of the through-hulls.
The article discusses in more detail and I'm not sure I've yet arrived at the correct solution for my boat and plan to double-check everything at the next opportunity.
On Dec 3, 2020, at 15:36, William Shannahan via groups.io <shannahanwilliam=yahoo.com@groups.io> wrote:
So I removed the old diesel and am getting ready to install the electric motor. Was reviewing Don Casey's book and came across the illustration showing the whole DC System being grounded to the diesel engine block.Since that is no longer there what should I ground to?
No comments:
Post a Comment