Wednesday, December 16, 2020

Re: [electricboats] Cs30 Thunderstruck conversion

Hi Jesper,

i'm thinking of a similar project, would love to come check out what you are doing, i'm just down the estuary from you at Alameda marina. 

On Wed, Dec 16, 2020 at 8:07 PM <jesper.malmberg86@gmail.com> wrote:
@jeremy

It's not terribly difficult. Although I did have experience with similar software before. I'm sure you can find some tutorials on YouTube. The thing that takes some getting used to is "drawing" with commands rather than the mouse. For example, to make a rectangle you specify the starting corner, then type the other corner in a x and y coordinate fashion.

For the pieces I made it's quite basic use of the software. But it's worth it, the throttle pieces came out at about 7 or 8 usd a piece. They (sendcutsend) have a minimum of 29 usd per order for stainless steel however so i had to make sure to make most of the orders together. They also have normal steel, brass, copper etc so have given me some ideas for future projects.

Most of these online cutter providers give you an instant quote as well when you upload the drawings. 

_._,_._,_

Groups.io Links:

You receive all messages sent to this group.

View/Reply Online (#31053) | Reply To Group | Reply To Sender | Mute This Topic | New Topic
Your Subscription | Contact Group Owner | Unsubscribe [newarmyguitar24@gmail.com]

_._,_._,_

No comments:

Post a Comment