Sunday, June 20, 2010

Re: [Electric Boats] mars brushless 48v controller

 


THANKS VERY MUCH

i moved the throttle + wire to #10 in the connector instead of 11. one sevcon manual says 11 but i found reference to a 16 pin setup that says go #10...i tried that and was much relieved that it worked! now on the to the boat parts of the boat work....

mb

--- In electricboats@yahoogroups.com, "aweekdaysailor" <aweekdaysailor@...> wrote:
>
> My sevcon setup has a contact switch mounted to the throttle - I think it is referred to in the docs as the "belly switch" - it must be closed in order for the unit to start. I will be up there today and see if I get six flashes if I leave it open - if so, that's what you need to connect.
>
> -K
>
> --- In electricboats@yahoogroups.com, "mboucher99" <mboucher99@> wrote:
> >
> > Thanks, Denny.
> > In fact, i had that doc, but your generosity is apprecited.
> >
> > For everyone... Happy Father's Day..
> > I was fuzzy about shifting wiring from my old Mars controller to the new Sevcon, but with Denny's info, and little phone support from Thunderstruck, i got to the point where i THOUGHT i had it all sorted out. and so my new PLEA to all of you.....
> >
> > i have double- and triple-checked the circuitry and despite being pretty sure that all the connections are correct, when i turn the key my sevcon unit is flashing 6 times...and the motor is not responding. my meter tells me i have 48volts in the battery pac, 48 v at the connector and 48 v at the Sevcon unit. the doc i saw suggests that 6 flashes indicates 'Accelerator Wire Off fault. i checked and that pos wire is in #11 as the list indicates. it's - mate goes to B-.
> >
> > any suggestions???
> > thanks,
> > michael
> >
> > --- In electricboats@yahoogroups.com, "dennis wolfe" <dwolfe@> wrote:
> > >
> > > Email me directly through my website and I will forward the wiring diagram.
> > >
> > > Denny Wolfe
> > > www.wolfEboats.com
> > >
> > >
> > > ----- Original Message -----
> > > From: mboucher99
> > > To: electricboats@yahoogroups.com
> > > Sent: Saturday, June 12, 2010 3:12 PM
> > > Subject: [Electric Boats] mars brushless 48v controller
> > >
> > >
> > >
> > > all
> > > i am about to replace my mars controller with the new Sevcon MillipaK unit. the connectors are different and the wiring diagrams vague - at least to the likes of me. i need to move wire ends from the mars 14 pin connector to the new sevcon 20 pin. has anyone done this - and clear lists the match the functions out there?
> > > thanks!
> > >
> >
>

__._,_.___
MARKETPLACE

Stay on top of your group activity without leaving the page you're on - Get the Yahoo! Toolbar now.


Get great advice about dogs and cats. Visit the Dog & Cat Answers Center.


Get real-time World Cup coverage on the Yahoo! Toolbar. Download now to win a signed team jersey!

.

__,_._,___

No comments:

Post a Comment