I see that you managed to get the runout down to 0.001" on the shaft from the motor. I have the thunderstruck reducer and it's not as sturdy looking as what you have manufactured and it sits at about 0.005" runout. I'm getting some vibration at higher RPMs but I'm pretty sure it's from the propeller which will be replaced next haulout. Would you say this runout is acceptable though? I was considering adding a pillow block style bearing in order to stabilize the shaft a bit.
Regards,
Jesper
_._,_._,_
Groups.io Links:
You receive all messages sent to this group.
View/Reply Online (#31774) | Reply To Group | Reply To Sender | Mute This Topic | New Topic
Your Subscription | Contact Group Owner | Unsubscribe [newarmyguitar24@gmail.com]
_._,_._,_
No comments:
Post a Comment