When you get the model number go to this website and look up the parts diagram for it.
It will tell you whether it's a resistance or PWM controller and how the shaft should fit.
If it's PWM I bet the throttle pot is either worn or dirty, you can order a new one from the above site.
I know on my older 50AT motors there is an opening in the top of the shafts that could allow water to enter the lower motor pod. In nearly ten years of operation on my boat I have never had that, and my motors sit out in all conditions including winter. Most of this time they are stowed on deck as they would normally with a bow mount design.
mattelderca
On Tuesday, July 15, 2014 12:10:47 AM, "V1opps v1opps@yahoo.com [electricboats]" <electricboats@yahoogroups.com> wrote:
This is an older moter seems to have a smooth throttle, not stepped ,
Will have to look up model number
Also on the top head there seems to be maybe a 1/2 gap in the upper and lower half
Should this be closed or taped off to keep water out or open gap to keep cooler??
Cheers
Scotty
Will have to look up model number
Also on the top head there seems to be maybe a 1/2 gap in the upper and lower half
Should this be closed or taped off to keep water out or open gap to keep cooler??
Cheers
Scotty
__._,_.___
Posted by: matt elder <mattelderca@yahoo.ca>
| Reply via web post | • | Reply to sender | • | Reply to group | • | Start a New Topic | • | Messages in this topic (5) |
.
__,_._,___
No comments:
Post a Comment