Tuesday, June 14, 2016

RE: [Electric Boats] Re: AGM Battery Anomaly

 

There's also NiCr wire: http://jacobs-online.biz/nichrome_wire.htm

Heavy gauge NiCr60 is used for heater elements (e.g. kilns, bathroom heaters) and for series resistance for early electric car speed switching.  You can make a quick resistor "coil" by wrapping, e.g., 11ga NiCr around a 1" diameter dowel, removing from the dowl and then connecting the ends of the coil to electric connections or studs of your choice.

 

-MT

 

From: electricboats@yahoogroups.com [mailto:electricboats@yahoogroups.com]
Sent: Monday, June 13, 2016 8:19 PM
To: electricboats@yahoogroups.com
Subject: Re: [Electric Boats] Re: AGM Battery Anomaly

 

 

I made a high wattage resister from some old standing rigging that had started getting meat hooks.  I noticed that it is 3/16 stainless steel which has a high resistance.  The wire rope was 19 strand.  I unwound one strand and measured it as about 1 ohm per meter of length.  I bent the strand into a shape that was compact but did not self intersect and short out.  It also allowed good air circulation to carry away the heat. I did a test where I passed about 7 amps through it at 10 volts of voltage drop for 70 watts.  I could feel the heat coming off of it like a small electric space heater.  I can make resisters of just about any desired amount of resistance and power dissipation ability and do it very cheaply this way.

Will


On Jun 13, 2016, at 21:20, oak oak_box@yahoo.com [electricboats] <electricboats@yahoogroups.com> wrote:

 

It can be a challenge to find high enough wattage resistors that won't fry when you try to discharge a battery.

 

One thing that I found that works reasonably well is to go find some halogen headlight bulbs for cars - they're designed for 12V, and generally draw up to 7 amps apiece.  Several of those wired in parallel will do the trick (though they can be a bit pricey).

 

John

 


From: "John Acord jcacord@gmail.com [electricboats]" <electricboats@yahoogroups.com>
To: electricboats@yahoogroups.com
Sent: Monday, June 13, 2016 7:21 PM
Subject: [Electric Boats] Re: AGM Battery Anomaly

 

 

Mike,

Another thing you can do to help your battery is to isolate it and do a deep discharge followed by a full charge.  You will need a low resistance high wattage load though.  For a 100AH 12V battery I use a couple of 1.2 ohm big ceramic resistors in parallel.  20 amps is a good discharge rate and battery heating is moderate.  Recharge at at least that rate.

John


--

Flatwater Electronics
www.flatwaterfarm.com
"Neurosurgery for computer looms."

 

__._,_.___

Posted by: "Myles Twete" <matwete@comcast.net>
Reply via web post Reply to sender Reply to group Start a New Topic Messages in this topic (8)

Have you tried the highest rated email app?
With 4.5 stars in iTunes, the Yahoo Mail app is the highest rated email app on the market. What are you waiting for? Now you can access all your inboxes (Gmail, Outlook, AOL and more) in one place. Never delete an email again with 1000GB of free cloud storage.


.

__,_._,___

No comments:

Post a Comment