Re: [electricboats] Mounting the sevcon gen4?

These were taken during the install.  The backside where you can see the heat sync if you notice the nuts on the right side they are the bolts holding the chargers on the back side.  They also have thermal grease between the aluminum plate and the aluminum stand.

On Jul 13, 2020, at 6:48 AM, Bob Jennings <heatnh@gmail.com> wrote:



Picture of my compartment

On Mon, Jul 13, 2020, 6:42 AM Bob Jennings via groups.io <heatnh=gmail.com@groups.io> wrote:

I used the optional heat sink. It was short money when I purchased the 10kw kit. Not sure if it makes a difference but the controller is mounted in the engine compartment so figured it couldn't hurt.

On Mon, Jul 13, 2020, 1:09 AM Ryan Sweet <ryan@ryansweet.org> wrote:

How have you folks mounted the sevcon controller? With the heat sinks on there doesn't seem to be a natural way to mount it. Do you put it on rods?  Or mount it with the heat sinks up against a panel?

Pictures anyone?

Thanks!

<20200506_131724.jpg>