Re: [electricboats] Mounting the sevcon gen4?

Thanks everyone! This has been helpful. 

On Jul 15, 2020, at 17:29, Harley Clark <clarkharley37@gmail.com> wrote:



The GEN4 is mounted on an aluminum plate offset by square tubing.

I felt more comfortable with this set up even though i was not planning on using more than 50 amps out of my 48 volt lithium battery pack.

On Mon, Jul 13, 2020 at 1:55 PM Reuben Trane via groups.io <rjtrane=me.com@groups.io> wrote:

I have a bulkhead just aft of the motor. I cut out a section to match the heat sink. I mounted the Sevcon on the forward facet of the bulhead with the heat sink penetrating into an open area over the shaft. Works like a champ. 

<IMG_9241.JPG>