In the meantime, I have a related question (maybe for ChristopherH?) around thrust bearings. I've decided to use a belt drive (like the photos above, but for a single motor and gear. But without the transmission I had planned on using (with integrated thrust bearings), I'm going to need to anchor the propshaft to the boat.
Christopher, what inline thrust bearing did you use? I'm trying to determine if I should build out a thrust bearing somewhere along the prop shaft, or whether I should integrate the thrust bearing into the engine mount, either before or after the belt pulley driving the shaft. Also, if there's a pre-made thrust bearing for boats, I can't seem to find them (except large ones for giant ships). Does anyone know what they'd be called, so I can search for them. (Yes, this is an embarrassing, totally newbie, question to ask, but I just can't seem to find them, so have been debating whether to just engineer my own from bearings off Granger or McMaster-Carr).
I'm not sure those questions even made sense, but that's where I'm starting... Still trying to figure out the best way to get this done!
This has been an amazing thread! Thank you!
_._,_._,_
Groups.io Links:
You receive all messages sent to this group.
View/Reply Online (#31211) | Reply To Group | Reply To Sender | Mute This Topic | New Topic
Your Subscription | Contact Group Owner | Unsubscribe [newarmyguitar24@gmail.com]
_._,_._,_
No comments:
Post a Comment