>>Hi, Dan
>>I will suggest 34CrNiMo6 alloy for your shaft.
>>>
>>>On Friday, 19 March 2021, 07:07:01 GMT+8, Dan Pfeiffer <dan@pfeiffer.net> wrote:
>>>Carsten, You mentioned that I should not bother with stainless steel for my small output shaft. What would you suggest for that instead?
I found this info:
https://steelnavigator.ovako.com/steel-grades/34crnimo6/
Is a 4340 a similar alloy? I can get that from McMaster. Cost is the about the same as SS. How hard will it machine in my lathe? I was prepared to machine the SS. Will this be tougher?
Also, I am figuring you have some background in all this?
Thanks, Dan Pfeiffer
I found this info:
https://steelnavigator.ovako.com/steel-grades/34crnimo6/
Is a 4340 a similar alloy? I can get that from McMaster. Cost is the about the same as SS. How hard will it machine in my lathe? I was prepared to machine the SS. Will this be tougher?
Also, I am figuring you have some background in all this?
Thanks, Dan Pfeiffer
No comments:
Post a Comment