Hi
Just wondering if you can use a 48 volt pack to run a 36 Volt DC motor.
I presume if you had a 48 Volt controller and limited the output to 36 Volts, it should work.
If I had a 48 Volt pack, a 48 Volt controller and put a volt meter across the motor leads and restricted it to 36 Volts, I would be OK.
am I missing something here, or would it work.
Thanks
__._,_.___
Posted by: Mark F <mark.internet@yahoo.ca>
| Reply via web post | • | Reply to sender | • | Reply to group | • | Start a New Topic | • | Messages in this topic (1) |
.
__,_._,___
No comments:
Post a Comment